Plinth Label Animations

How to change the plinth animation so it doesn't start in-vision

Step By Step Guide: How to change the plinth animation so it doesn't start in-vision

How to change the plinth animation so it doesn't start in-vision

Plinth Label Animation - Default

1 In this example it is using the blueprint controller for the column chart and some JSON. The chart has been postioned on the floor. As can be seen the label sits alongside the columns, but the issue is where it begins its animation from. Currently that would be from Z:-300, which would put below the floor.

Plinth Label - default start position Z:-300

2 Here we can see the start position -300, i.e. below the floor. Okay, so that is when the chart is positioned on the floor, what if it was placed on a studio table or a pedestal. The starting point may then be aboe the floor and would be seen in the preview.

'Animate From / Animate To' of -1200 / 0

3 Where to change the start point for the animation. Details / Animations / Plinth Label Animations Settings. Change the 'In Animation' and the 'Out Animation' so that the Mode: Locations Z' has an 'Animate From / Animate To' and an 'Animate To / Animate From' (respectively) of -1200 / 0 & 0/ -1200

Plinth Label Animation set to animate in from Z:-1200

4 What it now looks like prior to being animated in